The REV End Cap Bearing is used with the 5mm hex shaft recommended for the REV 15mm Extrusion System to provide a low friction rotating shaft support. This bearing is intended to seat in any of the plastic REV brackets with the 9mm ID bearing seat including: REV-41-1313, REV-41-1303 and REV-41-1304. The bearing has a larger diameter flange that helps retain the shaft and bearing against the bracket.
Specifications
- Material: Acetal (Delrin/POM)
- Bearing Surface OD: 9mm
- Bearing Surface Length: 9mm
- ID: 5mm hex
- Inside Hex Depth: 22mm
- Overall Length: 24mm
Documentation
- BuildingGuide
