This bearing pillow block bracket is used with the REV 15mm Extrusion System. The 9mm center hole is use with either the REV Robotics Long Through-bore Bearing (REV-41-1329) or the End Cap Bearing (REV-41-1322) to provide a low friction shaft support. This bracket has alignment ribs on the bottom which help align the bracket with the extrusion channel.
Specifications
- Material: Nylon (PA66)
- Bolt Area Thickness: 3mm
- Hole Diameter: M3 clearance
- Hole Spacing: 24mm
- Overall Length: 36mm
Documentation
- BuildingGuide